The Proper Way to Jump-Start a Car

Once in a while, you’ll find that your vehicle will need a jump-start car service. Whether you’ve accidentally left a light on or your vehicle has been sitting in Burlington for some time, you’ll need to jump-start your car battery. But, what if you don’t know how to properly jump-start your car? Fortunately, our service experts are here to help.

The proper way to jump-start a car isn’t complicated, but there are a couple of steps you’ll want to carefully follow to ensure that you’re doing it correctly. Learn how to jump-start a car today with the service professionals at Transwest Chrysler Dodge Jeep Ram! Then, schedule a service appointment to ensure that you rarely run into an issue where you need to jump-start your car battery.

How to Properly Jump-Start a Car

Of course, calling for a jump-start car service is one of the simplest ways to get you back on the Deer Trail roads. However, we know that not everyone has the ability to do that. Additionally, it’s a good idea to know how to properly jump-start a car in the first place in case you’re in a remote location without a phone signal. Luckily, the proper way to jump-start a car isn’t difficult to learn. With that being said, here’s how to jump-start a car:

1. Park both vehicles close enough that the jumper cables can reach the terminals on each battery.
2. With both vehicles in park, ensure that they’re off, engage the parking brake, and open the location where the battery is located.
3. Using jumper cables, connect the red clamp to the positive terminal of the vehicle with the dead battery. While doing this, ensure that none of the cable ends touch each other.
4. Connect the other red clamp on the jumper cables to the positive terminal of the vehicle with the working battery.
5. Now, connect the black clamp on the negative terminal of the vehicle with the working battery.
6. The final black clamp should be grounded by connecting it to an unpainted metal surface on the vehicle with the dead battery.
7. Start the vehicle with the good battery, and let it run for a couple of minutes.
8. Try starting the vehicle with the dead battery. If it starts, remove the jumper cables in the reverse order that you put them on.
9. That’s all that it takes to jump-start your car battery!

Jump Start Car Service Tips & Additional Advice

So, what happens if your car won’t jump-start? Or, maybe your car starts, but it keeps needing a jump-start during Bennett drives? There could be a jumper of issues at play. But, let’s take a look at some additional tips and tricks about jump-starting your vehicle:

• If your car won’t jump-start and all you hear is a clicking sound, it may not be the battery that needs to be serviced. You could have a starter that is simply malfunctioning.
• If everything turns on except for your engine, it could be because of a number of reasons. From your ignition switch to a fuse, it’s best to visit a service center for assistance.
• If your vehicle has successfully started but keeps on needing jump-starts, you could have a faulty alternator.
• After you’ve successfully jump-started your vehicle, we suggest you leave it running for a few minutes. This will allow the battery to recharge if needed and ensure you have enough power to start your vehicle again in the future.

Transwest Chrysler Dodge Jeep Ram Can Help You Learn How to Jump-Start a Car

If your car won’t jump-start and you’re stranded in Limon, we’re more than happy to help. We’re also looking forward to assisting you if you don’t understand how to jump-start your vehicle. For assistance on vehicle jump starts, feel free to reach out to us online!